Maintenance works of aquaculture roots blower

the daily use of aquaculture roots blower, we must do a good job in maintaining the maintenance. Let's take a look at this:

1. Check the fastening conditions of each part and the loosening of the positioning pin. If there is any loose, it should be tightened.

2. There is no oil seepage in the body of the blower.

3. No scaling, rusting and peeling phenomena exist within the aquatic system.

4. Pay attention to whether the oil cooling condition is normal, pay attention to the quality of lubricants, always listen to the blower for running the noise, and notice whether the unit is working under the conditions of not meeting the prescribed conditions.

Overload of the roots blower, aquaculture, sometimes not displayed immediately, so attention should be paid to the exhaust pressure, bearing temperature, and the change of the motor current, to determine whether the machine running normally.

6. When the machine is disassembled, the machine shall be measured with each matching dimension, make a good record, and mark and direction on the parts, so as to ensure assembly and keep the original matching requirements.

7. After the new machine or the major repair blower, according to the operation procedure, it is recommended to replace the whole lubricating oil after 8 hours

contact:

Name：Alisa Chen
Tel:  86 531 83216898  
Fax: 86 531 83216898 

Skype: +86 13853738666

E-mail:  dacheng@chinadicheng.com